(949) 407-8904 Mon - Fri 08:00 - 17:00 23661 Birtcher Dr., Lake Forest, California, USA
(949) 407-8904 Mon - Fri 08:00 - 17:00 23661 Birtcher Dr., Lake Forest, California, USA

3 Factors Affecting the Deposition Rate in Magnetron Sputtering

3 Factors Affecting the Deposition Rate in Magnetron Sputtering

Magnetron sputtering is a physical vapor deposition method that allows the deposition of various materials, including metals, oxides, ceramics and etc. by using a specially formed magnetic field applied to a diode sputtering target. The deposition rate, or the film formation rate, is an important parameter that measures the effectiveness of the magnetron sputtering machine.

There are several influencing factors of the deposition rate, including the type of the ambient air, the working pressure, the temperature of the sputtering target, the strength of the magnetic field, and so on. But today, we’re going to talk about the 3 important factors affecting the deposition rate in magnetron sputtering: the sputtering voltage, current and power.

Sputtering Voltage (V)

Experiment results have shown that the effect of sputtering voltage on film formation rate has such a rule: The higher the voltage, the faster the sputtering rate, and the effect is tempered and gradual over the range of energies required for sputter deposition. Among the factors affecting the sputtering coefficient, after the sputtering target material and the sputtering gas, the discharge voltage really matters. Generally, in the normal process of magnetron sputtering, the higher discharge voltage has a larger sputtering coefficient, which means the incident ions have higher energy. Therefore, the atoms of the solid target are easier to be sputtered out and deposited on the substrate to form a film

Sputtering Current (I)

The sputtering current of the magnetron target is in direct proportion to the ion current of the surface of the sputtering target, so it is also an important factor that affects the sputtering rate. There is a common law of magnetron sputtering that the deposition rate is fastest under the optimum gas pressure (according to different sputtering targets and different sputtering projects). Therefore, on the premise that the film quality won’t be affected and the customer’s requirements can be satisfied, it is appropriate to consider the optimum value of the gas pressure from the sputtering yield. There are two ways to change the sputtering current: change the working voltage or change the working gas pressure.

Sputtering Power (P)

The effect of the sputtering power on the deposition rate is similar to the sputtering voltage. In general, increasing the sputtering power of the magnetron target can increase the film formation rate. This is, though, not a universal rule. In the case that the sputtering voltage of the magnetron target is low (for instance, around 200 volts) and the sputtering current is high, although the average sputtering power is not low, the ions cannot be sputtered and cannot be deposited. The prerequisite is that the sputtering voltage applied to the magnetron target is require to be sufficiently high so that the energy of the working gas ions in the electric field between the cathode and the anode is sufficiently greater than the “sputtering energy threshold” of the target.

Voltage Current Power

From the above discussion, you can see that voltage, current and power actually interact with each other. The deposition rate in magnetron sputtering is never affected by one of them but all of them. Want to know the best parameters of these three factors for your project? Please send us an inquiry. The experienced team from Stanford Advanced Materials will give you a satisfactory solution for your project.

Stanford Advanced Materials, a global sputter coating manufacturer since 1994. Please visit https://www.sputtertargets.net/ for more information.

About the author

Julissa Green graduated from the University of Texas studying applied chemistry. She started her journalism life as a chemistry specialist in Stanford Advanced Materials (SAM) since 2016 and she has been fascinated by this fast growing industry ever since. If you have any particular topics of interest, or you have any questions, you can reach her at julissa@samaterials.com.

Leave a Reply